Quote Originally Posted by KTE View Post
Yeah Achim I want him to make the source code available or just edit it himself to add MSR values.
Well, found the WinRing0 library (http://openlibsys.org/manual/), should not be too difficult to write such an app with that lib.
Quote Originally Posted by KTE View Post
PSU: Picking it up tomorrow. Would be good if you had one to compare if we both pull different currents/watts for the same volts/settings.
Just ordered one, p-tune looks promising. Hope i can run the monitoring stuff on a different pc (assuming it connects via usb or similar).
Quote Originally Posted by KTE View Post
CnQ: If I change values whilst having CnQ enabled (through Windows+BIOS), CnQ doesn't fully kick in until I disable it within Windows and then enable it again. Loses me 3-5W AC idling.
I think this is normal behaviour, if the p-state changes the register get's copied to c0010070. Here it was enough to generate some load start/stop prime95 to force the switch.
Quote Originally Posted by KTE View Post
As you know, I've found I'm still stable at lowish volts for 204x13x9x9x2.66, 94W AC idling now writing this and having at least 11 other apps open. Still at the same volts you can see in my 3DMark06 run I posted in the MSI thread. It's been running for over 35 hours now at this setting, many reboots etc, but hardly any downtime. I'll move it up slowly, testing all CPU/IMC/HT/RAM for instability is a bit of a long winded hassle.
Must say i'm ok with 2.6GHz at 1,3375V (1,325V just froze). Max i got stable for more that 4hrs is 2.63GHz(~1,39375V). 2.64GHz freezes after ~half an hour with volts up to 1,45V, which is too much for me to run 24/7.
Can not get my idle consumption below 105W AC.