Quote Originally Posted by KTE View Post
So you're booting at 250HT and then after boot the system sets 280HT... far more than most 9600 BE's would go but then again, your board and BIOS are far better than many other boards and BIOSes people are trying. Maybe your chip is too.
Code:
TRFC0............................... - Auto
TRFC1............................... - Auto
With two DIMMs, set these two values to at least 195ns if you want to push oc using high HT ref. on both X2 and Phenom.
yeah i have to set initial boot to 250HTT and then 281HTT otherwise i won't get post, again, this is the same for all three processors. setting 282HTT just hangs at 25 during POST. i see everyone else running around with 350HTT+ without issue on this board with non-Phenoms but my 3200+ i have laying around shows the same symptoms. i would have accepted the Phenoms being limited there but not the 3200+

i have tried setting both to 195+ with no change in symptoms. thanks for the help though, i am stumped as to what is going on.