Today i was very excited as i received the package with the freezers.
Nicely packaged sent by airmail. From the day of purchase door to door 4 days! Excelent.
Each freezer is nicely packed in a air bubble bag.
By neo_rtr, shot with DiMAGE X1 at 2008-02-14
By neo_rtr, shot with DiMAGE X1 at 2008-02-14
Before I start I notice that the bottom place is not mirror like. This is the same for all freezers.
For the Mosfets you will need the pads from the original fusion block
For the Northbridge you will need the backplate and the screws from the original fusion block.
For the Southbridge screws, washers are provided
This is the Southbridge freezer
By neo_rtr, shot with DiMAGE X1 at 2008-02-14
Nice copper with 2 distance rings and plastic washers.
It has been said that: the fittings should be ¼” and the threads should have max. 5mm, if your fittings are longer than 5mm, then must use the distance rings which are included to every freezer.
Thus the of the HI-Flow Hose Barb - 3/8" (G-1/4" Thread) with the following specifications Thread Length: 4.5mm (.18") should fit and the distance rings are not needed.
Now that i try it on this happens
By neo_rtr, shot with DiMAGE X1 at 2008-02-14
The one with out the distance ring is not airtight. meaning that i must use the distance ring, who by the way was a O-ring. So one side fits the freezers and the other from the barb (O-ring) the distance ring.
By neo_rtr, shot with DiMAGE X1 at 2008-02-14
Reply With Quote
Bookmarks