**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[mrcape]

goodman,

Have you ever tightened up the heatpipe assembly including the NB sink?

I put some photos up earlier in the thread that show my experience replacing the tim for the whole assembly. The most noticeable thing during that process was that out of the box, the nb sink was pretty loose. Maybe a few turns of the screw could help things. If not, then a fan on the sink is a good solution. For PWMs I added some little mofset sinks to the CPLs which dropped my pwm tempe 3 or 4c.

http://www.xtremesystems.org/forums/...postcount=3204

http://www.xtremesystems.org/forums/...postcount=3397

FWIW, I tried every combination of copper plate, transpiper etc. and this worked best for me. I also have a stacker with 7 fans going. I think the most effective approach is simple, make sure everything is secure and blow air on it.