I just flashed over to 0109 from 11/07 and it seemed like the flash went alright (although it took a loooong time to finish). I used my floppy drive for flashing duties. Anyway after the flash I'm now getting some weird corruption within my "Voltages" tab in BIOS. Pretty much everything looks good, I've got the new lower "VTT" options but below that the settings are all messed up, can't even read them? It starts below the "Vroop Setting" and ends where you can either enable or disable the GTL's? I would take a picture but my camera battery just died earlier today. If you have this problem it would be very obvious to you because there is no way to properly read those options or set them? Please let me know ASAP because its got me nervous!