*Official Retail G0 Q6600 Overclocking Thread*

[ZenEffect]

Wussup guys any answers to the problem it keeps failing the 3dmark test i get a blue screen and crashes and fails occt test after 5 minutes i need some help cant seem to get it stable trying for a week

bios 907

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 9
FSB Frequency : 400
FSB Strap to North Bridge : 400
PCI-E Frequency: 110
DRAM Frequency: DDR2-800mhz
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time : AUTO
Write Recovery Time : AUTO
Read to Precharge Time : AUTO

Read to Write Delay (S/D) : Auto
Write to Read Delay (S) : Auto
Write to Read Delay (D) : Auto
Read to Read Delay (S) : Auto
Read to Read Delay (D) : Auto
Write to Write Delay (S) :Auto
Write to Write Delay (D) : Auto
DRAM Static Read Control: Enabled
Ai Clock Twister : light
Transaction Booster : disabled
Relax level: 0

CPU Voltage : 1.4000
CPU PLL Voltage : 1.60
North Bridge Voltage : 1.35
DRAM Voltage : 1.90
FSB Termination Voltage : 1.40
South Bridge Voltage : 1.075
Loadline Calibration : Enabled

CPU GTL Reference : Auto
North Bridge GTL Reference : Auto
DDR2 Channel A REF Voltage auto
DDR2 Channel B REF Voltage : auto
DDR2 Controller REF Voltage : DDR2-Ref
SB 1.5V Voltage : 1.5


NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU Volt
Voltiminder LED : Enabled

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

what is the vid of your cpu? my other 1.325vid q6600 g0 needed 1.5v to get 3.6... 1.64 to get 3.8 and i havent even tried for 4 on it.. i just got a different cpu

i would set clock twister to strong and trans booster to auto..