Quote Originally Posted by Iketh View Post
Spread Spectrum - Disabled
CPU Host/HTT Clock - 246MHz
CPU Host/HTT Boot Up Clock - 230MHz
CPU Host/HTT Adjust Gap - 2MHz
PCIE Clock - 100MHz

Onboard LAN1 - Disabled
Onboard LAN2 - Enabled
Onboard 3132 Mode - Disabled

CPU VID Control - 1.42500V
CPU VID Special Add - Auto
CPU NB Voltage Control - 1.35000V
CPU NB VID Special Add - Auto
DRAM Voltage Control - 2.07V
SB PLL 1.2V Voltage - 1.40V
NB Core Voltage - 1.370 V
NB PCIE Voltage - 1.120 V
NB HT Voltage - 1.400 V

Virtualization - Disabled
AMD K8 Cool&Quiet control - Disabled
NPT Fid control - x11
CPU-NB DID - 1
CPU-NB FID - 04
AMD CPU stepping - P0

HT Link Width - 16bit
HT Link Frequency - 1.6GHz
IH Flow-Control Mode - Disabled
HT Link Tri-State - Disabled
2x LCLK Mode - Disabled
UnitID Clumping - Disabled

Timing Mode - Manual
Memory Clock Value or Limit - DDR 800
DCTs Mode - Unganged
CKE based powerdown - Per Channel
Memclock tri-stating - Disabled
2T Mode - Enabled
CAS Latency Time - 4 CLK
Precharge delay (tRAS) - 12 CLK
DRAM RAS# Precharge - 4 CLK
DRAM RAS# to CAS# Delay - 4 CLK
Bank to Bank Cmd (TRRD) - 2CLK
TRC - 16T
TRTP - 2 CLK - 4 CLK
Write Recovery (TWR) - 3 CLK
Write-Read Command (TWTR) - 2 CLK
TRFC0-3 - 105.0ns
Trdrd - 2 CLK
TrwtTO - 3 CLK
Twrrd - 0 CLK
Twrwr - 1 CLK
CS/ODT Pin Fine Delay - Enabled
TLB Cache Mode - Enabled
Bank Swizzle Mode - Enabled
Auto Tweak Performance - Enabled
Optimal Performance Mode - Enabled
DRAM Drivers Weak Mode - Normal Drive
Output Driver Comp. - Auto

Advanced Chipset Features:
Memory Hole - Disabled
Memory Hole Remapping - Enabled
Auto Optimize Bottom IO - Enabled
Bottom of (31:24) IO space - C0
System BIOS Cacheable - Disabled

Onboard FDC Controller - Disabled
Onboard Serial Port - Disabled
Onboard IRDA Select - Disabled
CIR Port Address - Disabled

PCIE Configuration:
Secondary Dual Slot Config - Auto
P2P b/w Primary/Secondary - Enabled
GPP Power Limit, W - 25

GFX Port 1/3/4:
Gen2 High Speed Mode - Disabled
Link ASPM - Disabled
Link Width - Auto
Slot Power Limit, W - 75
PCIE GPP Link Width - 2.1.1.1.1

NB-SB Port Features:
Link ASPM - Disabled
VC1 Traffic Support - Disabled

HD Azalia Audio - Disabled
OnChip SATA Controller - Enabled
OnChip SATA Type - Native IDE

IDE DMA transfer access - Enabled
Primary IDE Controller - Disabled

OnChip USB Controller - Enabled
USB EHCI Controller - Enabled
OnChip USB KBC Controller - Enabled
USB Mouse Support - Disabled

ACPI Suspend Type - S1(POS)
C2 Disable/Enable - Disabled
Soft Off by PWRBTN - Instant-Off
PowerOn by PCI Card - Disabled
ACPI XSDT Table - Disabled
HPET Support - Enabled
POWER ON Function - BUTTON ONLY
PWRON After PWR-Fail - On
ATC Alarm Resume - Disabled

Init Display First - PCIEX
Resources Controller By - Auto
PCI/VGA Palette Snoop - Disabled
Assign IRQ for VGA - Enabled
Assign IRQ For USB - Enabled
PCI Latency Timer (Per 8CLK) - 8
INT Pin 1 to 8 Assignment - Auto
PCI Express relative items, Maximum Payload Size - 128
is this the setting that I should do??? THANK YOU!!