Quote Originally Posted by grimpy View Post
You should beable to run it at 1.35v for 4-4.2GHz.
Well, i'm running my E8500/Maximus/Mushkin 4GB XP2-8500 using these settings, and don't know what's the next step to raise

CPU Ratio Control: Manual
Ratio CMOS Setting: 9.5x
FSB Frequency: 400
FSB Strap to North Bridge: Auto
PCI-E Frequency: 105
DRAM Frequency: 1120
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Precharge: 4
RAS# ActivateTime: 12
Other Memory Timings: Auto
DRAM Static Read Control: Auto
Ai Clock Twister: Auto
Transaction Booster: Auto
CPU Voltage: 1,325 1,30 real
CPU PLL Voltage: 1,58
North Bridge Voltage: 1,45 1,47 real
DRAM Voltage: 2,22 2,30 real
FSB Termination Voltage: 1,36 1,28 real - and very strange, as with my E6850 it was higher than bios settings, now it's much lower...
South Bridge Voltage: 1,05
Loadline Calibration: Enabled
CPU GTL Reference: 0.63x
North Bridge GTL Reference: 0,67x
DDR2 Channel A REF Voltage: Auto
DDR2 Channel B REF Voltage: Auto
DDR2 Controller REF Voltage: Auto
SB 1.5V Voltage: 1,50
NB LED Selection: NB Volt
SB LED Selection: SB Volt
CPU LED Selection: CPU Volt
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
C1E Suppport: Disabled
CPU TM Function: Disabled
Vanderpool Technology: Disabled
Execute Disable Bit: Enabled
Max CPUID Value Limit: Disabled