Official GIGABYTE X38-DQ6/X38T-DQ6 Info/BIOS Thread

[Hornet331]

When I try 1T CR, cpu-z doesn't "apply" it, and seeing that Everest says I have it when I do not, I don't know what to think....

verify it with spi, just try the same timings and just alter the command rate.

If spi is slower with when 2T is eneabled you know it works and cpu-z just cant read it.

Hornet331: It does undervolt at any setting below that. I think there is a problem with voltage regulator overcorrecting at that point...not sure, maybe a bios bug though. Until Gigabyte releases a bios that doesnt default to 1333 on the memory though, I probably won't find out, or unless they do a non-beta release...my Vdimm is also jumpinng around a bit from 2.00 set in bios (+ .50) to 2.10. memory is slightly warm to the touch while priming, so I am not too concerned...

really strange behaviour, vdimm is also strange that it jumps so much.

did you disable all the advance feature of the cpu (C1E,EIST,NXbit etc.)

do you have any chance to measure the Vcc with a DMM?

No I've sorted out my FSB "problems".

I was just too shy with the vcore

geht doch.