spi1m @ 22.453s It froze after the run so I had to take a picture. It's on a friend's camera, I'll try to get it today![]()
I was very close to the coldbug limit, so I don't think I can push it too much more. It didn't like more volts either, but I'll try it more later. Need to get some 32m runs etc first (hwboints, you know). It was very hot, idle to laod difference was more than 20c! I guess I have to remove the ihs to get lower load temps.
I got it fro mebay a while ago, stepping is CAB1E 0622FPMW.
When I bench I don't bench 100% outside, I bench in the garage, so even if it's -5c outside in the middle of the night, it's not below 0 where the pc is. But does it matter that much? I mean, because of the neoprene, the ambient temp shouldn't change the pot temp.
Bookmarks