G80 8800GTS OCP + VDROOP MOD - Made & Confirmed Working!

[Timbosan]

I've played Crysis for 1,5 Hours with 1,45 V & 729 MHz - all works fine.

I did this with 1,5 V and it works, so 3dmark is not the stability test at all. Could you please try HL2EP2? If you do not want to walkthrough the game, here's my save: http://www.filefactory.com/file/1de604/. You need about 3 minutes (with 1280x1024xAll High) to test, if there is no OCP there - this will be the conclusive proof.

P.S. Just for informaton - the 78X resistors are 63,4 Ohm each.

I asked if you could bench @ 1.55v, not 1.45 & 1.50v. Again today i benched 03 nature & 06 at 1.62v idle 1.60v load - can you do that? (dont say you did at 1.5 and its the same as my 1.6v as its not )

im still not convinced, what you did by removing the 78X resistors is crazy and may be causing your problem. Your phase current sharing may well be out of whack and possibly other factors too. After removing the 78X resistors, i dont see why you added resistors across the caps - the OCP mod needs the 78X resistors to remain in place & the Isen circuit to be complete and functional.

Did you measure the resistance across the caps & to ground before and after soldering them on? Or did you just solder on 1.2k's as thats what i did? I measured mine & thats why i chose the 1.2k resistors - since you removed the others it may be you need different value to me, or need to replace the 78X resistors to retore functionality.

The mods are not the same, therefore not comparable. You may be running at totally different resistances, if the Isen circuit is even still active & functioning correctly on your card. Replace the removed resistors buddy, then say it doesnt work

Despite your result, i could never run above 1.45v idle no matter what the test or game before it would shut down, so it has achieved a substantial gain for me.

i will be busy till at least 2nd Jan, may download & install game after then.