**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[dMITIj]

Just got my P35 up and running, WinXP is loaded and patched, and everything seemed just fine. Well after installing my G80 driver 163.75 and rebooting I got a message saying, "Your Graphics Adapter is Not Receiveing Sufficient Power". Although I've heard of this message before I've never receieved it before. So I pulled out my DMM and measured each wire of both 6-pin connectors (all reading 12.41v), then I measured both VGPU and VMEM and the cards core and memory were receiving exaclty the correct voltages? I've tried plugging in the additional Floppy 4-pin connector to the plug above my card (next to NB) but still get same message. Just to let you know I've also got the 8-Pin connnector installed and it's also reading correct voltages all around. Last but not least I checked most of the ATX wires and their all reading correct voltages so I have no idea what the issue is, any ideas guys? Have any of your received this message after getting your DFI P35 up and running?

PSU: OCZ 700w GameXtreme

i Got that exact same problem...... did you find a solution?
i to have bin running for 6 months whit other mobo's (maximus & 8800GTX, maximus & 3870 @ CF) whitout any problems, so it could only be the GFX ore the mobo.