I just can't get anything over 400x9 stable. Not even OCCT stable. Here are my current settings for 400x9 which is both OCCT and Prime stable:
I've tried 412x9 for 3.7GHz, but it always fails. I've upped all the voltages and still I can't get it stable.Code:Thermal Management Control Disabled PPM (EIST) Mode Disabled Limit CPUID MaxVal Disabled CIE Function Disabled Execute Disable Bit Disabled Virtualization Technology Disabled Core Multi-Processing Enabled Exist Setup Shutdown Mode 2 CLOCK VC0 divider AUTO CPU Clock Ratio 9x Target CPU Clock 3600MHz CPU Clock 400FSB Boot Up Clock AUTO DRAM Speed 266MHz/667MHz Target DRAM Speed DDR2-1000MHz PCIE Clock 100MHz Voltage Settings CPU VID Control 1.425v CPU VID Special Add AUTO DRAM Voltage Control 2.05v SB Core/CPU PLL Voltage 1.640v NB Core Voltage 1.479v CPU VTT Voltage 1.530v VCore Droop Control Disabled Clockgen Voltage Control 3.45v GTL+ Buffers Strength Strong Host Slew Rate Weak GTL REF Voltage Control Enabled x CPU GTL1/3 REF Volt 106 x CPU GTL 0/2 REF Volt 106 x North Bridge GTL REF Volt 107 DRAM Timing Enhance Data transmitting FAST Enhance Addressing FAST T2 Dispatch Disabled Channel 1 CLK Crossing Setting More Aggressive Channel 2 CLK Crossing Setting More Aggressive CH1CH2 Common CLK Crossing Setting More Aggressive CAS Latency Time (tCL) 5 RAS# to CAS# Delay (tRCD) 5 RAS# Precharge (tRP) 5 Precharge Delay (tRAS) 12 All Precharge to Act AUTO REF to ACT Delay (tRFC) AUTO Performance Level 7 Read delay phase adjust SEE BELOW MCH ODT Latency AUTO Write to PRE Delay (tWR) AUTO Rank Write to Read (tWTR) AUTO ACT to ACT Delay (tRRD) AUTO Read to Write Delay (tRDWR) AUTO Ranks Write to Write (tWRWR) AUTO Ranks Read to Read (tRDRD) AUTO Ranks Write to Read (tWRRD) AUTO Read CAS# Precharge (tRTP) AUTO ALL PRE to Refresh AUTO PCIE Slot Config 1X 1X CPU Spread Spectrum Disabled PCIE Spread Spectrum Disabled SATA Spread Spectrum Disabled read delay phase adjust press enter Channel 1 Phase 0 Pull-In AUTO Channel 1 Phase 1 Pull-In AUTO Channel 1 Phase 2 Pull-In AUTO Channel 1 Phase 3 Pull-In AUTO Channel 1 Phase 4 Pull-In AUTO Channel 2 Phase 0 Pull-In AUTO Channel 2 Phase 1 Pull-In AUTO Channel 2 Phase 2 Pull-In AUTO Channel 2 Phase 3 Pull-In AUTO Channel 2 Phase 4 Pull-In AUTO
I'll have 3DMark scores for the HD2900Pro at these settings later.
Reply With Quote
Bookmarks