Lets talk breaking the HTT 230 limit on k10 here

[EvilBellyLint]

No clue, I'm using the Promise T3 controller on my K9A2 for Raid 1. I have my main 150gb Raptor on the SB600 controller and i cant access it if i switch the controller to raid. Also the Promise T3 controller is a tad buggy in x64 so dont trust my main drive to be on it.

Sounds like an old bug that hasn't been fixed. When the RD600 Northbridge
was introduced along with a (different, non-SAS) Promise controller on the
DFI LanParty ICFX3200, and both the SB600 RAID and the Promise RAID
were configured, the Promise Boot ROM would prevent the ATI Boot ROM
from enabling.

Apparently the workaround was to configure each RAID separately.
But you had to disable one controller's ROM, configure the other
controller for RAID, then reverse the process, then re-enable both
controller ROMs, and you could then run both the ATI and Promise
RAIDs at the same time.

I would have thought ATI and/or Promise would have fixed this by now.



EBL