Lets talk breaking the HTT 230 limit on k10 here

[KTE]

Changed up or down?

If this is the case it would be best to leave VID at default...1.25V and use the "special add" option say in the DFI genie bios only.

Thing is i have VID to 1.5V+...used 1.4 etc with no issue so i am thinking you mean undervolting?

I can't change it down but can change slightly up. CPU VID 28 is 1.250V, but sometimes it is 1.2000V randomly. I tried CPU VID 29 and it showed as 1.1875V in AOD. 27 has no POST and 29 has reboot at Windows loadup.

Macci said earlier: "note typically CPUs are locked to 1.25V or 1.30V VID value so trying to set higher than this might result in non-BOOT"

Run HT 9x and NB 9x, both CPU/NB dividers to 1 (which is 0 in your BIOS I think), HT ref. to 240MHz. Try feed it approximately 1.35V CPU, 1.25V HT, 1.3V NB.

If HT ref. 240 is stable, it should bootup I'm thinking but you may need to increase PCIe to 105-109 to get it stable and be running like so:

CPU: 2640MHz
NB: 2160MHz
HT: 2160MHz

Like this:


Is that not possible on yours?