**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[C-N]

any recommended timings for 4 gigs of d9's... im completely loss when its comes to 4 gigs of ram

See this review, there's a lot of 4GB testing & setting info.

http://www.anandtech.com/mb/showdoc.aspx?i=3129

I prime95 my system today at 1080mhz with 4GB of ram at 5-5-5-12. It failed after 8h32m. A in the mouth to say the least. Sure, it lasted 8h which is what most people go by, but to have it fail shortly afterwards leaves a bad taste in my mouth. It technically should have went forever until I stopped it. Why would it go so long then finally fail? I have to make some adjustment someplace. I want it to go for at least 10h before I am satisfied. The setting was 450 X 7 for 3150mhz cpu clock. Not too high on the cpu but I am trying to max out my memory before I up the multi to see what I come up with.

99% sure its RAM timings or voltage see my list attached @ 8 hours + all that is being tested is ram.

I pretty much always run 1 hour of prime custom 4096k before letting blend run one full 9 & 1/2 hour loop (Thats stable enough for me) which eliminates 8 hour + failures

CN