Hmmm load testing at 230w...
Compressor is only consuming about 285w
In comparison, previous prototype would be consuming about 325w or so under same load condition. Efficiency, efficiency

This is the limit right now unless I want to put another trick up the sleeve. No suction line accumulator in use and almost 0 flood back under no load :P
customer originally wanted 250w tuned but that would mean killing temperature by about 3-4c. I am not sure if that is worth it at this point for 20w capacity as the trick involves that unfortunately. There was some complication I originally had with Cryostar evap that has been resolved after some reworking of unit.
I better ask customer what he prefers... honestly though, i think this is better route to go with 4c improvement on temp for similar load where 6600 q0 stepping stopped for 1.7v or so