Goliath Triple Cooling System

[Sweeper]

A few more stupid questions.
Why are there 3 ports on one of your distribution blocks but 4 on another?
Will the orientation of the motherboard be vertical or horizontal?
What are the dimensions of the inside of the chill-box?
How will you seal the seam of the box to cope with sub zero temps?
Will the box have an insulated metal panel like the other sides of the box or will it have a transparent window?

If it is a transparent window:
What type of material will you use for the window?
How do you plan to control the condensation on the outside of the window?


Sorry to take up your time but this is intriguing.

When the receiver tank was originally made, I added a extra port to access the tank from outside the chamber to fill the liquid loop. Not sure I will use it....if not, I will block it off.

The motherboard will be mounted vertical like most computer cases...I want to show off all the copper blocks and some other "Bling Bling" parts.

The inside dimensions of the cooling chamber is 16 1/2" H x 19 1/2" W x 15 1/2" D.

Are you referring to seam outside where the two chambers were assembled? If so, the seam will be caulked with silicone.

There will be a removable 1/2" thick transparent window which is made of laminated polycarbonate ( AKA Lexan ). Laminated polycarbonate is two layers of glass heat treated together with a rubber layer between them. This makes the glass stronger and acts as insulation when exposed two different temperature conditions. The glass is used in high security facilities such as prisons and jails. I should know...I build prisons for a living.

Hope this explains