Ok, here we go then
Ai OVerclocking Tuner : [Manual]
CPU Ration Control : [Manual]
Ratio CMOS Setting : 9
FSB Strap to North Bridge: [266]
FSB Frequency : 445
PCIE Frequency : [100]
DRAM Frequency : [DDR3-1781]
Dram TIming COntrol : [Manual]
Pri. Information:
CAS# Latency : 7
RAS# to CAS #Delay : 6
RAS# Precharge : 6
RAS# Active Time : 18
RAS# to RAS# Delay : Auto
Row Refresh Cycle Time: Auto
Write Recovery Time : Auto
Read to Precharge Time : Auto
Sec. Information:
Read to Write Delay (S/D) : [Auto]
Write to Read Delay (S) : [Auto]
Write to Read Delay (D) : [Auto]
Read to Read Delay (S) : [Auto]
Read to Read Delay (D) : [Auto]
Write to Write Delay (S) : [Auto]
Write to Write Delay (D) : [Auto]
DRAM Static Read Control : [Disabled]
DRAM Dynamic Write Control: [Disabled]
Ai Clock Twister: [Strong]
Ai Clock Skew for Channel A: [Auto]
Ai Clock Skew for Channel B: [Auto]
Ai Transaction Booster [Enabled]
Level 3
**** Please key in voltage numbers directly! ****
CPU Voltage: [1.56850] = 1.53-54 real
CPU PLL Voltage: [1.70]
FSB Termination Voltage [1.40~]
DRAM Voltage [1.98]
North Bridge Voltage [1.55]
South Bridge Voltage [Auto]
Clock Over-Charging Voltage [1.00]
**************************************************
CPU Voltage Damper [Enabled]
CPU Voltage Reference [Auto]
North Bridge Voltage Referemce[Auto]
CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]
Tried Setting Transaction Auto and soo, Lower mem speed, more vmem, more and less and disabled of everything... with my Commando it was 16h stable
now its not..
Will be changing for Maximus Extreme.. im allready tired of this
if its no better than Commando, why keep it?
I didnt Really test it with orthos, but i DID put it on for heattesting time to time, and it didnt hang up, but After 601, i was going to do the same, and it goes from 1 to 8 sec and BSOD nomather what.. i got all cpu settings Disabled, and only Jmicron and Realtek Enabled. nothing else.
Originally Posted by oscar3d
Reply With Quote
You have a nice wife there.
Bookmarks