I never use floppy's cause of that very reason. The disks just go bad with age and the drive fail fairly often at the wrong times. XP is very old now going on what 7 years old I think. I've never installed MCE but I would hope it would allow you to use USB for raid drivers.

@ 1.6v on NB I get 50* ish idle temps. I'm @ 1.47v (1.52v on PC Probe) NB and my NB is at 47* idle and it gets to about 56* after 30 minutes of full load. I think my NB isn't making good contact with the heatsink. Got a few tubes of MX2 coming so when it gets here I'll be reseating the NB and SB sinks and see how my temps are after that.

Every time I fail OCCT it's when vNB gets a small voltage spike. I'm going to pull out my DMM here next week and check my Power from the PSU to see if it's fluxing or if it's the boards voltage regulators. I would still like to know what I can mod to up the output of the boards 3.3v and 5v regulators. If it's the PSU I'll definitely be doing something to fix it but I highly doubt it's the PSU as everyone is showing the same voltages. I've got almost all my setting green now and stable @ 400x9. I'll post up what I've got here very soon for settings.