Official ASUS X38 Boards: P5E, P5E3 - Info/BIOS Thread

[Skyline GT-R]

Ok got my P5E But because the socket area is packed with all the copper I can't install my Zalman coolers. Tryed both the 7000B Cu and 9500LED Using stock intel cooler now

[Xelation]

Forgot my main bios settings:

Extreme Tweaker

Ai Overclock Tuner [Manual]
CPU Ratio Control [Manual]
- Ratio CMOS Setting [9]
FSB Frequency [333]
FSB Strap To North Bridge [Auto]
PCIE Frequency [100]

DRAM Frequency [DDR2-1111MHz]
DRAM Command Rate [2T]
DRAM Timing Control [Manual]
Primary Info: 5-5-5-15-3-42-6-3
CAS# Latency [5 DRAM Clocks]
RAS# To CAS# Delay [5 DRAM Clocks]
RAS# Precharge [5 DRAM Clocks]
RAS# Active Time [15 DRAM Clocks]
RAS# To RAS# Delay [3 DRAM Clocks]
ROW Refresh Cycle Time [42 DRAM Clocks]
Write Recovery Time [6 DRAM Clocks]
Read To Precharge Time [3 DRAM Clocks]
Secondary Info" 8-3-5-4-6-4-6
Read To Write Delay (S/D) [8 DRAM Clocks]
Write To Read Delay (S) [3 DRAM Clocks]
Write To Read Delay (D) [5 DRAM Clocks]
Read To Read Delay (S) [4 DRAM Clocks]
Read To Read Delay (D) [6 DRAM Clocks]
Write To Write Delay (S) [4 DRAM Clocks]
Write To Write Delay (D) [6 DRAM Clocks]

DRAM Static Read Control [Auto]
Ai Clock Twister [Auto]
Transaction Booster [Auto]
VCORE Voltage [1.3500]
CPU PLL Voltage [Auto]
FSB Termination Voltage [Auto]
DRAM Voltage [Auto]
North Bridge Voltage [Auto]
Sout Bridge Voltage [Auto]

Loadline (Calibration) [Auto]
CPU GTL Reference [Auto]
North Bridge GTL Reference [Auto]
SB 1.5v Voltage [Auto]

CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]

Advanced
CPU Configuration

CPU Configuration [Manual]
CPU Ratio Control [9]
Ratio CMOS Setting [Disabled]
C1E Support [Disabled]
CPU TM Function [Disabled]
Vanderppol Technology [Disabled]
Execute Disable Bit [Disabled]
Max CPUID Limit [Disabled]

fingers hurt from typing pff

PS 1.35v in Bios is 1.312 in CPUz (with little bit of fluctuating), is this correct or
does it need to be 1.35v in CPUz?

[camouflage]

Forgot my main bios settings:.................

Try this:

Extreme Tweaker

Ai Overclock Tuner [Manual]
CPU Ratio Control [Manual]
- Ratio CMOS Setting [9]
FSB Frequency [333]
FSB Strap To North Bridge [Auto]
PCIE Frequency [101]
DRAM Frequency [DDR2-1111MHz]
DRAM Command Rate [2T]
DRAM Timing Control [Manual]
Primary Info: 5-5-5-15-3-42-6-3
CAS# Latency [5 DRAM Clocks]
RAS# To CAS# Delay [5 DRAM Clocks]
RAS# Precharge [5 DRAM Clocks]
RAS# Active Time [15 DRAM Clocks]
RAS# To RAS# Delay [Auto]
ROW Refresh Cycle Time [Auto]
Write Recovery Time [Auto]
Read To Precharge Time [Auto]
Secondary Info" 8-3-5-4-6-4-6
Read To Write Delay (S/D) [Auto]
Write To Read Delay (S) [Auto]
Write To Read Delay (D) [Auto]
Read To Read Delay (S) [Auto]
Read To Read Delay (D) [Auto]
Write To Write Delay (S) [Auto]
Write To Write Delay (D) [Auto]

DRAM Static Read Control [Enabled]
Ai Clock Twister [Auto]
Transaction Booster [Auto]
VCORE Voltage [1.3500]
CPU PLL Voltage [1.5]
FSB Termination Voltage [1.3]
DRAM Voltage [1.8 - 2.1]
North Bridge Voltage [1.41]
Sout Bridge Voltage [Auto]

Loadline (Calibration) [Disabled]---------> Do the pencil Vdroop mod !!!
CPU GTL Reference [Auto]
North Bridge GTL Reference [Auto]
SB 1.5v Voltage [Auto]

CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]

Advanced
CPU Configuration

CPU Configuration [Manual]
CPU Ratio Control [9]
Ratio CMOS Setting [Disabled]
C1E Support [Disabled]
CPU TM Function [Disabled]
Vanderppol Technology [Disabled]
Execute Disable Bit [Disabled]
Max CPUID Limit [Disabled]

Good luck

[camouflage]

Just posted here some EVEREST numbers for compario(#16):

http://www.xtremesystems.org/forums/...d.php?t=165329

[Xelation]

Ok got my P5E But because the socket area is packed with all the copper I can't install my Zalman coolers. Tryed both the 7000B Cu and 9500LED Using stock intel cooler now

Weird, got the Zalman CNPS9700 LED installed with no problems at all?
7000 series I can understand perhaps of the upward fan, but 9000 series
with horizontal fans would defenitly fit.

My only problem was that the 4x120 fan side-door of my CM Stacker 832,
I had to forced-close it. Because it hits the CPU Cooler a bit.

[Skyline GT-R]

Weird, got the Zalman CNPS9700 LED installed with no problems at all?
7000 series I can understand perhaps of the upward fan, but 9000 series
with horizontal fans would defenitly fit.

My only problem was that the 4x120 fan side-door of my CM Stacker 832,
I had to forced-close it. Because it hits the CPU Cooler a bit.

Well the cooler fit and so does the mounting bracket, but not the iron thing to actualy mount the cooler. It's to wide. And it's differrent for the 9700, I know this since I just installled a 9700 on my friends P5B Del

[Xelation]

Well the cooler fit and so does the mounting bracket, but not the iron thing to actualy mount the cooler. It's to wide. And it's differrent for the 9700, I know this since I just installled a 9700 on my friends P5B Del

Oh yeah that, but how do you have it? Turn it around, pff have to go to a
birthday now. But if not solved by when I get home, I shoot a photo for ya
of how I have it

[Xelation]

Can take the pictures more clearer then this

Well the cooler fit and so does the mounting
bracket, but not the iron thing to actualy mount
the cooler. It's to wide. And it's differrent for the
9700, I know this since I just installled a 9700 on
my friends P5B Del

[Xelation]

Thinks it's stable

Extreme Tweaker

Ai Overclock Tuner [Manual]
CPU Ratio Control [Manual]
- Ratio CMOS Setting [9]
FSB Frequency [370]
FSB Strap To North Bridge [Auto]
PCIE Frequency [101]

DRAM Frequency [DDR2-1111MHz]
DRAM Command Rate [2T]
DRAM Timing Control [Manual]
Primary Info: 5-5-5-15-3-42-6-3
CAS# Latency [5 DRAM Clocks]
RAS# To CAS# Delay [5 DRAM Clocks]
RAS# Precharge [5 DRAM Clocks]
RAS# Active Time [15 DRAM Clocks]
RAS# To RAS# Delay [3 DRAM Clocks]
ROW Refresh Cycle Time [42 DRAM Clocks]
Write Recovery Time [6 DRAM Clocks]
Read To Precharge Time [3 DRAM Clocks]
Secondary Info" 8-3-5-4-6-4-6
Read To Write Delay (S/D) [8 DRAM Clocks]
Write To Read Delay (S) [3 DRAM Clocks]
Write To Read Delay (D) [5 DRAM Clocks]
Read To Read Delay (S) [4 DRAM Clocks]
Read To Read Delay (D) [6 DRAM Clocks]
Write To Write Delay (S) [4 DRAM Clocks]
Write To Write Delay (D) [6 DRAM Clocks]

DRAM Static Read Control [Enabled]
Ai Clock Twister [Auto]
Transaction Booster [Auto]
VCORE Voltage [1.3500]
CPU PLL Voltage [1.5]
FSB Termination Voltage [1.3]
DRAM Voltage [2.10]
North Bridge Voltage [1.41]
Sout Bridge Voltage [Auto]

Loadline (Calibration) [Disable] -> Vdroop Pencil Mod
CPU GTL Reference [Auto]
North Bridge GTL Reference [Auto]
SB 1.5v Voltage [Auto]

CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]