Quote Originally Posted by Maglin View Post
Here are my current settings. I'm still going to work on getting some of the voltages down and getting some of the auto voltages set to what is stable so I don't have to worry about them changing and causing instability between boots.

I have noticed one thing not mentioned in this thread yet. Transaction Booster is just a stupid name for memory performance Level. If Disabled it starts at PL 7 and it goes up from the relax level which can be 0-7. And if Trans Booster is enabled it starts at I think 6 and goes down from what you put into Boost Level (name changes according to if TB is enabled or not).


Code:
BIOS 0701
Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8
FSB Frequency : 450
FSB Strap to North Bridge : 333
PCI-E Frequency: 100

DRAM Frequency: DDR2-1081
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 12
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : Auto
Write Recovery Time : 6
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6
DRAM Static Read Control: Enabled (Doesn't seem to effect bench's?)
Ai Clock Twister : STRONG
Transaction Booster : Disabled 
Relax Level : 1

CPU Voltage : 1.43125v
CPU PLL Voltage : Auto
North Bridge Voltage : 1.61v
DRAM Voltage : 2.00v
FSB Termination Voltage : 1.54v
South Bridge Voltage : AUTO
Loadline Calibration : ENABLED
CPU GTL Reference : .63x
North Bridge GTL Reference : .67x
DDR2 Channel A REF Voltage : AUTO
DDR2 Channel B REF Voltage : AUTO
DDR2 Controller REF Voltage : DDR2_REF
SB 1.5V Voltage : AUTO

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED : ENABLED

CPU Spread Spectrum : Enabled
PCIE Spread Spectrum : Enabled
i think CPU/pcie Spread Spectrum should be disable to add stable ！