ASUS Maximus Formula SE

[crazyea]

These are the settings I have used to get my 4x1gb pc8500 tracers stable at 1066 as well as oc my q6600 to 3.6@400x9. The biggest issue is the discrepancy between the bios settings and the voltages in windows/bios hardware monitor. This set up is prime stable over 8 hours with round off checking and alaso super_pi 32m stable, and memtest86+ over several hours. I hope it helps someone.

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : AUTO
CPU Ratio Control : Manual
- Ratio CMOS Setting : 9
FSB Frequency : 400
FSB Strap to North Bridge : Auto
PCI-E Frequency: 100
DRAM Frequency: DDR2-1066
DRAM Command Rate : 2T
DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 25
Write Recovery Time : 6
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6
DRAM Static Read Control: Auto
Ai Clock Twister : Auto
Transaction Booster : Auto

CPU Voltage : 1.41875 = 1.4
CPU PLL Voltage : 1.52 = 1.648
North Bridge Voltage : 1.49 = 1.520
DRAM Voltage : 2.12 = 2.224
FSB Termination Voltage : 1.40 = 1.472
South Bridge Voltage : 1.05 = 1.088
Loadline Calibration : Enabled
CPU GTL Reference : Auto
North Bridge GTL Reference : Auto
DDR2 Channel A REF Voltage : Auto
DDR2 Channel B REF Voltage : Auto
DDR2 Controller REF Voltage : Auto
SB 1.5V Voltage : 1.5 = 1.552

NB LED Selection : NB Volt
SB LED Selection : SB Volt
CPU LED Selection : CPU VOlt
Voltiminder LED :

CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled

Advanced CPU Configuration
CPU Ratio Control : Manual
- Ratio CMOS Setting : 9
C1E Suppport : Disabled
CPU TM Function : Disabled