As an update:

After passing 9hr at 1625 DDR 800, the BIOS started not showing voltages. Then it started failing in Vista. It finally passed Prime95 back down at 1500. I have reloaded the BIOS v801. I am going to assume that the BIOS lost its mind.

You are supposed to go in little steps when overclocking but with this board it is like trying to hit a 1/2 point shot. You have to back up and jump in at a much higher level. With enough research you can see that the voltages being used are very consistent. With cooling temps are not an issue.

I will try 1700 +/- and 1000 DDR +/- next weekend. If it does not work then I am going for a new MB.

In conclusion, this board needs a new BIOS version to work.