**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[n00bstorm]

Guys please help me get prepared for this next one... when I get the new board... what should I do first? I already have the PSU inside... all the standoffs are in the case... ( by the way how do you place a bolt in one of them? its behind this tube... can't figure it out... don't feel like taking parts off from the MB to get that bolt in there ) . So take out the MB when it comes... place the CPU in there ( Q6600 ) ... place the MB in the case... place some thermal paste... install the Thermalright 120 Xtreme... install one stick of ram... ( Which one? (1) 512MB Kingston 667 (2) 1GB Crucial 800 (3) 1GB Corsair 1066? ) in the closest to the CPU slot the first one? Connect the 24 pin and 8 pin from PSU to MB.. then install the videocard and connect that too... and turn it on?...

[Brother Esau]

Guys please help me get prepared for this next one... when I get the new board... what should I do first? I already have the PSU inside... all the standoffs are in the case... ( by the way how do you place a bolt in one of them? its behind this tube... can't figure it out... don't feel like taking parts off from the MB to get that bolt in there ) . So take out the MB when it comes... place the CPU in there ( Q6600 ) ... place the MB in the case... place some thermal paste... install the Thermalright 120 Xtreme... install one stick of ram... ( Which one? (1) 512MB Kingston 667 (2) 1GB Crucial 800 (3) 1GB Corsair 1066? ) in the closest to the CPU slot the first one? Connect the 24 pin and 8 pin from PSU to MB.. then install the videocard and connect that too... and turn it on?...

First thing you do is get some replacement adhesive tape from TT and peel the sticker off and re apply The screw just leave that one out as I seriously doubt even if you went through the effort and got it in ....how did you plan on reinstalling the heat pipe assembly