**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[Seanie's Show]

I got my board back from RMA and finally set it up this weekend. I am running a QX6850 and my PWM temps are out of control. My pwm temps hit 80+ during prime95 then the board shuts down. Do I need to set-up the transpiper? Where is the best place to put a fan to cool this b**ch down? Here is a shot at 8x475(3.800ghz). Specs in sig ,any help would be appreciated.

Well on my NB and my PWM I just brought a hard drive cooler and removed the two 40mm fans out of it, I then screwed one to the heatsink on the PWM's and another blows through the fins on the NB heatsink, for 40mm fans they are do an excellent job, especially compared to yours, and completely quiet.

Soz about the picture quality: