**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[Raja@ASUS]

@raju........Good morning hey hows about a look see at my post above and give me you're opinion please? Also whats going to fair better in this board my G-Skill HZ's or my Crucial Ballistix Tracer (PC2 8500) ?

Hi man,

AFAIK both the HZ's and Crucial use Similar Micron D9, with possibly the Crucial 8500's being a better bin. A cross comparison on your end should confirm which of the 2 sets scale better..

For the most part I would encourage you to use the 266 strap dividers. Either toy with cas 4 clocking under ddr 1100 (depending on how good a vdimm you can get away with). Or use Cas 5 for over ddr 1100 clocking. This will immediately give you a bandwidth and latency boost (use enhanced addressing and enhanced data transmitting to fast).

Of course this will require increasing your currently low Vdimm/VNB/GTL settings...

One thing that may be worthy of merit to you is scaling down the 3.6ghz clock I posted at the club to a lower divider if you don't want to take the hit in voltages. THe OCZ Flex is micron D9 based too, so should allow some room for similarities...

regards
Raja