Quote Originally Posted by empty1969a View Post
Has anyone else experienced issues with their 3.3v line?

When running stability Testing with Prime around 3600 Mhz the 3.3v line will drop off to 0v. I did not notice this at first because I was using Everest to record readings. After adding Smart Guardian this became apparent with bios and Everest readings showing the same.

The 2 - PSUs I have seen this happen on were the primary Corsair 620W and then I popped in an old Power PC and Cooling 510.

Since this has happenned on 2 Power Supplies was wondering if this is a bios issue (no big deal), will try on another PSU to confirm (no big deal) or a MB issue which would be a big deal to make sure I get an RMA from newegg for a replacement.

Empty
SGuardian has issues reading correct temps and voltages, the rails are likely fine. I tested Vdimm droop under load and could not find the variance that was shown in SG.

regards
Raja