**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[Raja@ASUS]

Upto 450fsb matching VNB and VTT levels is quite effective. Hence the 1.61 VNB setting with a VTT of 1.6 (1.58 real), falls in at a nice 115/115/115 or so, close enough.

You may find that matching up with lower VTT/VNB/GTL's work, however, you will approach ratios of FSB where under 1.5VNB just won't hold the bandwidth.

I cannot in any way beat the Prime stable @ 3.6 with any other combination of settings for equivalent CPU mhz (prime stable that is). The only way to do so would be to run cas 4 with a very good pair of sticks that can run near 1100 or so with less than 2.27V (within warranty specs), at 450 fsb Cas 4 (on the same dividers), the VNB is likely to need another boost.

Hence why I thought 8x450fsb 2.1vdimm @ Cas 5 was so effective and gives superior performance to ddr 1200 cas 5 @ 400fsb on the 9x multi.. 1.61 on the NB will not put as much strain as prolonged use of DDR2 over 2.25v, 2.1vdimm really is sweet for the performance the 450fsb point gives on the 266 divider.

Once my Cas 4 ram gets back from RMA I will be in a position to watercool the CPU for in excess of 3.8ghz stable, then I shall be looking for around 430fsb @ Cas 4, to see what kind of voltages are required to hold the board/cpu/mem down...

regards
Raja