**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[fornowagain]

Yeah its the PCP&C in the sig. Finally got the computer to boot, decided to use the jumper instead of the EZ-CMOS clear and it booted fine. Not sure why I was getting the 8.2 error code. Looks like its time to dig out the MM and check voltages. This whole thing is frustrating to say the least. I'm assuming its just possible that 1.35 vcore bios, 1.26-29 full load isnt enough juice to achieve a stable clock. Back tot he drawing board. On a positive not the AS5 droped my temps a few degrees compared to the Cremq.

Why not put a few more volts through it for a bit to see if that cures it? You're expecting a lot for that to be stable at 3.3GHz if its dropping to 1.26v. I'd set to about 1.48v to see the actual around 1.4v and see what happens, you won't hurt it, just keep an eye on temps. Same goes for the MCH and VTT, just bump them up, when you find the cause slowly drop them and check the results.