**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[C-N]

I ordered this from Newegg...I hope it does better with quads than my Abit IP35-PRO does...it sems that DFI's own "transaction booster" doesn't work properly? Strange that they would include it when droop seemed quite minimal from what I've seen people in people's posts.

Slightly off topic but my IP35 Pro rocks with C2D & Quad what problems were you having?

Q6600 @ 3700MHz http://s106.photobucket.com/albums/m...208%203700MHz/

E6600 @ 3760MHz http://s106.photobucket.com/albums/m...208%203760MHz/

I just got the DFI last night hooked it up & within an hour ran 525 x 7 3D stable with my E6600 on the stock Intel Heatsink!!!

Although I could run 540fsb on the IP35 Pro it was not stable & would freeze in 3D (3DMARK01, 03 ,05 06 etc) so I think the DFI will definitely run higher fsb easier however it is atm (very early days) on auto timings & significantly slower than my ASUS P5K & Abit IP35 so its going to take a lot of tweaking

I also had problems with CPU-Z v 1.40.8 BETA so found v1.41.0 BETA which is reporting 1.536v @ idle with the vdroop thingy enabled in the BIOS, the actual vcore set in the BIOS is 1.50v so as you can see its not drooping much & as you are probably aware is considerably less droop than the IP35 Pro.

I have only played roughly for a few hours with the DFI but so far it looks to only droop 0.02-0.03v with light ish vcore (1.50) under load which is great.

CN