**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[luihed]

Well...I am not mad but I did chop off the stock coolers in order to install HR-05 for NB and HR-05 SLI for SB (yeah I know, it is kinda an overkill)
The reason I cut it off is because I had to keep the stock PWM cooler (couldn't find anything else that fits PWM area)
I did install a 40mm fan over PWM tho
Now I am very happy w/ the temps (all use push pins, pwm 35c/50c idle/load)

When I was using water for the nb, I used some OCZ bga ramsinks for the mosfett and they worked really well.... my PWN temp was lower than with the stock heatpipe... I used (8) full sinks and (4) 1/2 sinks and put one on each mosfett with some AS5, then I used a lil bit of crazyglue to stick all the bga sinks together to make one big heatsink.... Since each mosfett has its own sink, contact is perfect.... easily 5c cooler than stock at load....

[cLOUDFAn]

When I was using water for the nb, I used some OCZ bga ramsinks for the mosfett and they worked really well.... my PWN temp was lower than with the stock heatpipe... I used (8) full sinks and (4) 1/2 sinks and put one on each mosfett with some AS5, then I used a lil bit of crazyglue to stick all the bga sinks together to make one big heatsink.... Since each mosfett has its own sink, contact is perfect.... easily 5c cooler than stock at load....

sounds good
but how do you stick that big heatsink onto mosfet? crazyglue it as well? (I have some AS adhesive left, maybe I will try that)

[luihed]

I didnt have to use anything cos my board lays flat instead of upright in a case, the as5 is enough to keep them from moving around.... These sinks came with thermal tape and they were very good but I just yanked these from my commando...

http://www.ocztechnology.com/product...s-discontinued