Quote Originally Posted by Soulburner View Post
I'm wondering how you got a PWM temp even remotely close to that high.

Granted I haven't fired up my IP35 Pro yet, but my IP35 PWM is running at 53c full load with the only mod being AC MX-1 replacing the stock thermal pad. I can't tell how effective it was - I never did a before/after test because I didn't want to take the thing apart to get back to the PWM again.

Is the Pro really that much hotter?

I also edited my previous post - 1.350 vcore in BIOS gets me 1.288v in CPU-Z. Abit EQ is the same but it rounds to 1.29v.
Every board I've use (Epox 9npa, DFI NF4 and the IP35 mid level) have all showed high PWM temps easily above 80c on dual burns, some higher than 100c. Unless you keep your room at 70F and the vcore at stock you'll too problably get +80c on a dual burn.