Well i finally set up the new computer. I still need to update the bios to ver. 11 but here is what she looks like right now. The temps bother me a little for being on water. I followed AS Crem. Instructions to a "t" but i still get these wierd differences in core temp. I have C1E and ESIT dissabled in the bios ATM. If i enable those the temps drop but for some reason it "underclocks" the cpu when im not doing anything.

On a side note I booted at 2.997Ghz/333mhz, 1:1, 1.25 Vcore, 2.2 mem voltage and the temps didnt look to bad. Ran a 5minute small ftt stress test and the max temp's i saw were 47C core 0,2 42C core 1,3. Seems my cores 1 and 3 run 5C cooler than 0 and 2.

Time for the good ol' 24 burn in of the cremq. then its time to see what she will do.

Do you guys think my temps are high for being liquid?

Liquid Set up:

MPC655
MCR320 (yate loon pull config)
Dtek Fuzion
Micro Res.