Thank you! Well, naturally 1600MHz FSB (400Mhz) is currently the lowest bus speed you can run DDR3-1600 memory at. It's not very easy to determine if higher bus speed gives an advantage when you're trying to stay at the same CPU speed. E.g. for DDR3-1600 you could run either 400MHz FSB at 1:2 ratio or 480Mhz FSB at 3:5 ratio. However there is no way you can keep the same CPU speed at those above mentioned FSB speeds - 400x9=3600MHz and 480x8=3880MHz or even 400x7=2400MHz and 480x6=2880Mhz. That makes apples-to-apples comparison not quite possible. But if one has a CPU that maxes out at 3600Mhz and DDR3 that pulls DDR3-1800, I would naturally prefer 450x8 at 1:2 (resulting in e.g DDR3-1800C7) rather than 400x9 at 1:2 (that is DDR3-1600C7).
Well, time will tell if this will be a material for another "what's better - D9GMH or D9GKX" that some enthusiasts have been asking in regards of Micron DDR2 chips.
Looks pretty good to me... As for your title, I'd shoot a PM to one of the admins - e.g. njkid32. He'll be happy to help you!
*************
One thing I'd like to mention to those of you interested in playing with tRCD and tRP is that a vast majority of 1800C7DF and 1600C7DHX should allow to tighthen those timings to tRCD=6 and tRP=6 without a voltage bump. However we decided not to make it an official spec and leave up to you to mess around with it
Asus P5K3 Deluxe ------------------------------ Gigabyte P35T-DQ6
24hrs SP2004 - DDR3-1800 7-6-6 @ 2.00v ------------- 24hrs SP2004 - DDR3-1800 7-6-6 @ 2.00v
![]()
At those lower latencies there is a few seconds to gain in e.g. SuperPi 32M, which we all like to bench here. Below, side-by-side on P5K3 Deluxe. Just as above, no memory settings has been altered in Windows and Memset window is opened just to provide additional info.
SuperPi 32M - DDR3-1800 7-7-7 @ 2.00v ------------- SuperPi 32M - DDR3-1800 7-6-6 @ 2.00v
![]()
![]()
Bookmarks