QX6700 ES @ 3.6ghz 1.53vcore - 12hr p95 stable



Failed prime after 7hrs with 1.45 so upped it to 1.53 to be sure. Passed now so I can lower the vcore back down a little and test again. Not bad vdroop either - 0.032. Vdrop however is worse than the dual cores - 0.075

Load



Idle



Not a G0 nor a 6600 but hey for the price I paid I can't complain - not bad for a B3 chip (L632A865)

One thing I have noticed though is that when I get a failed overclock the board goes into '--' mode and at first I was having to reset the cmos and enter all the settings again. I have since just left the pc unplugged for around 2 mins and I can then get into bios without having to reset cmos to get it to boot.

I am also having power issues with the Zeus 750w. Whenever I power off and power back on again the motherboard reacts as though there is a short (there is none) and I again have to wait a minute with it unplugged until it will power back up.