this is a great guide but I might just have 1 question though, its probably a stupid one because Im fairly new to the pre installation of phase change.

here goes...

Wont the varnish and other stuff you put on the motherboard but particularly the varnish cause issues with the board later down the road, like for example on the R50s on an evga 680i, if one was to smother them with conformal coating, dielectric grease and even so if the varnish was making contact with it as its near the socket on this board, then would this not cause problems especially when some users like to stick BGA sinks over the R50s to keep them cool... I imagine the TIM would react with the materials being used for insulation here?

Thanks in advance for your answer to my probably stupid question