Asrock 775Dual-VSTA Volt Mods

[Jor3lBR]

Hi Jor3lBR, to answer your question there is no need to worry about the polarity of the pots. None of the legs are assigned a polarity and for the vmods there is no right or wrong way to solder the middle and outer legs, except of course soldered the two outer legs

Simple solder the middle leg to one point and one of the outer legs to the other point. I often refer to "Ground" in my mods but that is because it's a ground reference for bleeding off voltage to, it's not because it has to be attached to a corresponding ground on the pot.

Hope this helps

John

Hey J.Bravo! Thanks for the quick reply! Wow thats easy I will do that then.

a) If I perform the vcore mod I don't need to do it on the cpu right? Is it better for OC do it by the vcore mod or the cpu pin mod? (I can't find the vcore measure point).

b) Can I use a 20k pot on VTT instead of 10K, I run out of 10k's...

Has anyone tried to raise vdd voltages (north bridge)?

THANKS for your help! And congrats on your results.