Quote Originally Posted by virtualrain View Post
To setup and install a RAID array, you should do the following:

- First ensure only the drives you want in the array are connected to the mobo... disconnect all other drives until after Windows is installed and running.
- Boot to motherboard bios and enable RAID on the SATA ports you are using
- Reboot and enter the RAID bios (wait for it to flash during the POST process and press the appropriate key)
- Build your RAID array using the desired stripe size
- Reboot into motheboard bios and set your RAID array as your first HD boot device
- Reboot and install Windows... load RAID drivers using F6 in XP or when prompted in Vista
- Everything should work fine.
- Reconnect your other hard drives (if any).
Thank you very much

I wish, you could put your little guide in your blog