Well, my new mobo finally showed up last week. Along with 3 high speed yate loons and some thermal paste. Some quick numbers:

3.2Ghz @ 1.38v

44C Idle
53C Load


Just reformatted, so I don't have the gpu numbers yet, but I think they were around 45C. I ran a 10 hour orthos before I reformatted, and it was stable, but I need to do some further voltage tweaking and what not. I'll post more numbers and pictures within the week.

I did have one major problem that I did not fix and need help solving. In my stupidity, when I sent the mobo back I took the cpu block off of course. I then left it attached to the loop in the case. This would have been fine, but I accidently touched it in all my frustration. The finger prints ended up tarnishing it somehow. You can clearly make out my finger prints on the block. I cleaned it the best I could but the finger prints won't go away. I hate to think that the only solution now is to lap it. Any suggestions? The block is currently installed with finger prints. Do you think my temps are greatly effected by it?

Thanks,
Dateranoth