Quote Originally Posted by Senater_Cache View Post
I cant really tell very well how you have the loops ordered because I cant see th epumps in the pics.
Here is how I would do it.

CPU Loop:
D5>MCR220>Fuzio>NB bottom barb>res (from the NB upper barb)

GPU Loop:
D5>PA>lower GPU>upper GPU>res

just a thought. The bend from Fuzion into the lower barb on the NB block will be much better.

Also, have you thought about mounting the pumps against the front bezel down there? or on some bracket? I mean mount them so that the inlets are facing up and the outlets are shooting towards the back of the case. I think this may you may be able to mount the pumps side by side along the width of the case front. Also the bends on the pump inlet tubing will be much less and the outlet bend will be minimal.
My loops do go the way you have just discribed. All I have to do is change the tubing to goes from the fusion oulet to the bottom barb on the EK nb.

I played around trying loads of differant ways to mount the pumps.

The way you say about having them with the inlets facing up would mean that you would not able to turn the power flow dile at the back of the pump because it would be covered by the case floor.