Hey, can you tell me the markings on the chip I've circled in red on the pic I attached?
If it is a W83320G, can you measure resistance between ground and pin 8 of the chip?
Edit: I believe it is a W83320G. I've marked pin 8 in red on this pic: http://home.no/aasmaukr/image.jpg
The vdimm mod for your board should be soldering a VR between pin 8 of the chip and ground. A general rule to figure out what ohm value your VR needs to be, multiply the resistance between ground and pin 8 by 20.
I.E. if the resistance is 2kohm you need a 40kohm VR (or 50kohm will do too, but preferably not any lower than 40kohm).
Reply With Quote
Bookmarks