Illustrative Guide: Modify your Scythe Infinity mounting system...

[BobHarris]

This is the kit from Jab-tech that you're referring to, correct?

this is the ninja mounted to my board with the TT bolt-thru kit. i put washers between the spring and the mounting clips to apply more pressure.

That looks like the perfect mount for the Infinity. If the springs work for the 120 Ultra, the proper compression should fall within the same ballpark for the Infinity with the added washers. The springs for the mod on the first page are completely compressed already so they may not be strong enough.

How would you turn those screws? The infinity blocks the top of those screw heads. Can you just push down, squeeze the bolt head with your fingers and turn? Or can these screw heads only be used with the Ninja because the opening at the corners allow a long screwdriver to fit through?