Quote Originally Posted by ninjaskija View Post
Hi guys.. i rly appreciate what u are doing here, and i think this thread helped many ppl, and i want to think that i am one of them but this days i am very frustrated because of my results...

I have a E6600 on a XBX2 cupled with a pair of 2x1Gb G.Skill 6400-BHK

I've been running these very stable (16h Orthos - large) :
Vcc=1,525
Enhanced Power Slope=Enable
MCH=1,575
vFSB=1,272
FSB=390

CPU=3.511Hmz

memory:4-4-3-5
vDIMM=2,16
Reference=266
Freq=533 1:1

But after i played a little with memory, trying divisors, etc my system was very unstable(instant resets) on Orthos - large, even with the same settings that i knew for sure they were stable..

I thought it was the memory but i tested every stick individualy and they were ok.. i dont know what to think.. i checked and rechecked temps, they are more than ok.

Pls if someone could help me - gtj?? (sry for my bad english)

Tx in advance..

P.S. : is an open bench and my room temp is around 20-22.
Hmmm. I'd try dropping your FSB back down to 340 or so leaving all other settings as above. Then work your way back up again and see where you become unstable. It's possible you were on the edge at 390.