Quote Originally Posted by ranker View Post
Any idea where to go for a comprehensive site for sleeving, molex modding, psu modding instructions? I'm on the last leg of finishing off my system for good and I'm looking to cut my ATX cable from my PSU down by half of its length as well as relocating molexes and sleeving them. However, I'm a bit scared to just read tid bits here and there and jump in. A PCP&C 1K PSU doesn't come cheap...
I found a link on sleeving which was very descriptive - will try to find it for you. I used that information to do the fans on the rad shroud. After that its dead easy to do.

You just need a good soldering iron (with flame adapter for heat shrink shrinking), solder, sleeving, heat shrink, good set of cutters, electrical tape, sharp scissors to cut electrical tape, molex pin removers, bite your tongue and off you go. ALWAYS remember to make a note of the pin-out of ANY cables you remove from a molex connector (or take a photo for visual reference).

I have also purchase some extra wide sleeving which I will be using to help hide some of the power supply cables which wont be needed. Next supply I buy will definitely be modular in design - MUCH better idea.

Once you have done a couple of sleeves, its quite infectious