Project "CUBEIT"

[GeoffP]

If in doubt, RTFM


Should have done this in the first case.

As I'm doing a pull config, I think it should go fan>gasket>shroud>rad>case>fan grill

I also have some 120mm fan filters - got them, just not sure if I really need them.
If I used them, I think they would go rad>filters>case>fan grill <--- Is this OK?

Do filters reduce air flow much? They would make it easier to keep crap out of the rad and inside of case, very easy to clean with a vacuum cleaner as well.

I also have a second gasket. I could do fan>gasket>shroud>rad>2nd gasket>case>filter>fan grill

Is it more of an advantage to have the rad hard up against the case (metal to metal) for better heat transference & dissipation into the case?