RD600 first look and general questions

[dasa]

oh, and if you use above settings poster's for strength, i think 2.0v vdimm is almost too much or DIMMs will sustain damage.

hmm so upping that puts more stress on the ram dose it
so running this 24\7 may not be so healthy?


e6600
2x1g TEAM XTREEM 800@4-4-4-12 D9GMH
http://i3.photobucket.com/albums/y83/dasa09/pc.jpg
http://i3.photobucket.com/albums/y83/dasa09/pc1.jpg

Control CPU Frequency: Manual
x CPU Frequency (Mhz) 390
PCI-E Overclock: 160
Software Reset Clockgen: Enabled
Memory Overclocking: Enabled
Overclock Frequency (Mhz): 475

CPU Vid Control: 1.5v
CPU VID Special ADD: AUTO
DDR2 Ram 1.8 Voltage: 2.34v
CPU VTT 1.2V Voltage: 1.31
NB Core 1.2V Voltage: 1.48
NB PLL 1.8V Voltage: 2.13
NB PLL 1.2V Voltage: 1.21
NB PCI-E 1.2V Voltage: 1.22
NB Core 1.2V convert from: 2.14
SB Core 1.2V Voltage: 1.23


CS Output Timing: Delay 1/4 Clock
CK Output Timing: AUTO
Dual channel Split Mode: Auto
ADDR/CMD Driving Pre-AMP: Disabled
ADDR/CMD Driving Strength: 15
Clocking Driving Pre-AMP: Always
Clocking Driving Strength: 15
Address/Command Timing: 1T
Memory Timing Select: Manual

CAS Timing (TCAS): 4
Read RAS-CAS Delay (TRCDR): 4
Write RAS-CAS Delay (TRCDW): 2
RAS Precharge Time (TRP): 4
Cycle Time (TRAS): 8

Row Cycle Time (TRC): 12
Refresh to Active (TRFC): 28
Bank to Bank CMD (TRRD): 3
Write Recovery (TWR): 5

Read-Write Command (TRTW): 3
Write-Write CS (TWTW_CS): 2
Write-Read Command (TWTR): 3
Write-Read CS (TWTR_CS): 2
Read-Read CS (TRTR_CS): 2
Read Data Transfers: 5