They made their decision that they are certianly not importing 965s? That's a load of. Mass mail HQ, about BRONET. Suckers....
They made their decision that they are certianly not importing 965s? That's a load of
i5 3570k | Asrock Z77 e4 | F3-2666CL11D-8GTXD | GTX660Ti | HX650 | 2xU2312HM
I have serious problem with this board. It is new, but not working, if i push the Power button, board is getting in endless restart loop ... no post, nothing, only restart after restart ...
It is normal and i am doing something wrong? Or RMA? I ve tested TWO memories, TWO CPUs, TWO GFX and the same result ...
remove all power from the board and clear the cmos, power back up, jumper bac k to normal, use a single stick of ram in the 3rd or forth slot and see if it will boot. On a cleared boot like this, the board should spin up for a couple of seconds, power down, spin up again, power down, and then boot up...Originally Posted by OBR
If it does boot set the vdimm up at 2-2.1v and save cmos, remove power from the board and insert the other stick of ram, try powering up again. If this does not work, see if you can try some different ram, try to avoid any ram that has been run with high vdimm for excessive periods, if using older stuff. Promos and elpida types use lower vdimm intrinsically, even micron d9 should boot at 1.9 if it has not been run hard for longer periods. Failing this the problem is either SPD related or you may need to rma the board..
regards
raja
Posting Permissions
Reply With Quote
Bookmarks