Can you tell me detailed what he did to get 1.4v? Please explain it in a newbie way
http://www.xtremesystems.org/forums/...ad.php?t=92874

Here's my picture edited by illuminati-hwt from above thread.



Alexio



--Red is the "D511 to ground mod" VID 3 to ground
--Green is VID 0, VID 1, VID 2 shorted. VID 0 is the ground(low) that pulls down VID 1 and VID 2 to zero.
--Blue is the effect of doing both mods.

Since VID 3 is grounded it is always going to be zero. That leaves the range of .975 to 1.15 to work with. Some values won't work. It seems if you could set 1.1 or 1.15 via a BIOS mod, you would only be toggling VID 4 so you would set the voltage to 1.15v. That would probably work if you can actually get the BIOS to set VID 4. For example I think VID 0 is hardwired to ground by design(not changeable). It's not like a BIOS mod can overvolt this card as it is already at 1.55v for this VRM table. Let me know. I was picking through your first mod in Hex Compare, I'd try it myself but I don't have any Hex tools at work, plus I have some things to take care of this afternoon.

EDIT : Also there is more extreme mod that gives the Intel VRM 9 table which is different then the hammer above. SO a modded BIOS would need to be tailored to each if this BIOS mod actually ends up working.