Hi All..

i have recently taken a step towards a more decent wc solution after having a H100

so i ordered a kit from aquatunig

http://www.aquatuning.nl/product_inf...ng-S--1oe.html



Contents

. 1x Magicool Xtreme I 120 Radiator
. 1x Laing DDC-Pumpe 12V DDC-1T (Swiftech MCP350) Retail
. 1x Laing Silencer Set (Klettmatte + 60x60mm Dämmung)
. 1x Ausgleichsbehälter Magicool Plexiac 150 extern
. 1x Coolplex / Plexiac Befestigungsschrauben M4
. 1x Lüfter 120mm Yate Loon D12SL-12 mit Stecker
. 1x Adapter 4Pin (12V) auf 3Pin Molex (7V)
. 3m Schlauch PUR 10,3/7,5mm Flexible
. 1x Fertiggemisch AT-Protect-Plus 500ml
. 6x 11/8mm (8x1,5mm) Anschraubtülle AG 1/4
. 1x CPU Kühler Phobya CPU Waterblock S.1366
. 1x detaillierte bebilderte Aufbau und Bedienungsanleitung

So far so good..

As a little extra for myself i also have purchased a XSPC RX360 Triple 120mm Radiator Rev 2.

My idea was to have the big rad cool my cpu, from there on there would be a loop to the smaller rad that came with the water-kit and that would cool my gpu as soon as i had the water block for it.

For now my i intend to only cool my CPU. After a little while i had the cooling installed and started up my rig.

Immediately i noticed that there was no flow. The pump worked but seemed unable to get the juices flowing.

As a result my cpu became too hot and throttled.

What is going on? Are the tubes too long? Did i pick the wrong holes to connect to my reservoir? the reservoir has 3 holes, 2 are normal bottom openings and one has a tube that runs inside the reservoir.



I hope someone can help me out.

Thanks in advance